Prescolite RLF8CFH User Manual download pdf

InstructionSheet

www.prescolite.com Prescolite TollFree Technical Support 1.888.PRS.4TEC Hours: 8am - 5pm ET

701 Millennium Blvd, Greenville, SC 29607

With representatives ofﬁces in principal cities throughout North America.

1/6/10

Part No ....................................................... 93026628

Sheet 1 of 2

IMPORTANT SAFETY INFORMATION. READ AND FOLLOW ALL SAFETY INSTRUCTIONS. Follow label information and instructions

concerning Wet or Damp Locations, installation near combustible materials, insulation, building materials, and proper lamping. Do

not install in areas subject to combustible vapors or gases. Before wiring to power supply and during servicing or relamping, turn

off power at fuse or circuit breaker. All servicing or relamping must be performed by qualiﬁed service personnel.

Product must be grounded to avoid potential electric shock or other potential hazard. Product must be

mounted in locations and at heights and in a manner consistent with its intended use, and in compliance

with the National Electrical Code and local building codes. The use of accessory equipment not recommended by the

manufacturer or installed contrary to instructions may cause an unsafe condition. Do not block light emanating from product in

whole or part, as this may cause an unsafe condition. Do not allow items such as drapes, curtains, screens or the like to come into

contact with the product or to block light from the product, as this may cause an unsafe condition.

WARNING - This product contains chemicals known to the State of California to cause cancer, birth defects and/or other

reproductive harm. Thoroughly wash hands after installing, handling, cleaning, or otherwise touching this product.

NOTE: Complete installation video can be seen at: www.prescolite.com. On homepage select: Media > Videos > Retroﬁcient.

PREPARATION: Current reﬂector and lamp must be removed. Supply line must be disconnected to current socket. The current

socket can be set aside above the ceiling or removed completely. Power must be turned off and the supply line must be

brought to the opening in ceiling as on page 2.

A. Connect quick connect (1) to the supply line. Remove junction box cover (3) attach supply line to junction box (4) through

one of the knock-outs provided in junction box (4). Attach connector (1) to connector (2). Put all wires inside of junction box

(4) and install junction box cover (3). (SEE FIG. 1)

WARNING: DO NOT pinch wires between J-Box/ballast cover and J-Box. Consult a qualiﬁed electrician for all other options

that require other wiring conﬁgurations. Make sure all connections are tight and secure.

B. Slip junction box Assembly and ﬂange ring (9) through hole in ceiling. (SEE FIG. 1)

C. With housing (6) in ceiling, the housing (6) can be rotated as needed to clear existing ﬁxture obstacles and/or to be

positioned best for the ﬂexible conduit, etc. If additional adjustment is needed, screw (7) and/or screw (8) can be loosened

and junction box (4) can be further moved. Ensure that screw (7) and (8) are retightened after this step. (SEE FIG. 5)

D. While pressing the bottom ﬂange (9) tight against the bottom of the ceiling insert one support(10) into slot as shown. Press

support (10) down against the top of the ceiling and tighten screw (11). Repeat this step for other support (10). (SEE FIG. 6

AND 7)

E. Make sure that housing unit (5) is down through ceiling opening. Remove wing nut from socket housing unit. Place three

small reﬂector holes around post and two extrusions of the socket housing unit. If the reﬂector (11) has dissimilar lamp

windows, the largest lamp window needs to face the lampholders Place wing nut back onto post over the reﬂector; then

tighten. Lampholder(s) will be aligned with lamp windows in reﬂector. (SEE FIG 8)

F. Install socket housing unit (5) through ceiling opening facing away from the J-Box (4). Push reﬂector towards ceiling until

reﬂector ﬂange is ﬂush against the ceiling. (SEE FIG. 9)

G. Install proper lamp/s.

SEE PAGE 2 FOR ILLUSTRATIONS

INSTALLATION INSTRUCTIONS

RLF6CFH AND RLF8CFH

1 2

InstructionSheet 1

Summary of Contents

Page 1 - InstructionSheet

InstructionSheetwww.prescolite.com Prescolite TollFree Technical Support 1.888.PRS.4TEC Hours: 8am - 5pm ET 701 Millennium Blvd, Gree

Page 2

InstructionSheetwww.prescolite.com Prescolite TollFree Technical Support 1.888.PRS.4TEC Hours: 8am - 5pm ET 701 Millennium Blvd, Gree

Related models: RLF6CFH

Comments to this Manuals

No comments

Prescolite RLF8CFH User Manual

Browse online or download User Manual for Lighting Prescolite RLF8CFH. Prescolite RLF8CFH User Manual

Summary of Contents

Related models: RLF6CFH

Comments to this Manuals

Related products and manuals for Lighting Prescolite RLF8CFH