Prescolite LF8MH EB User Manual download pdf

InstructionSheet

www.prescolite.com Prescolite TollFree Technical Support 1.888.PRS.4TEC Hours: 8am - 5pm ET

701 Millennium Blvd, Greenville, SC 29607

With representatives ofﬁces in principal cities throughout North America.

07/01/08

Part No ....................................................... 93015343

Sheet 1 of 1

IMPORTANT SAFETY INFORMATION. READ AND FOLLOW ALL SAFETY INSTRUCTIONS. Follow label information and instructions

concerning Wet or Damp Locations, installation near combustible materials, insulation, building materials, and proper lamping. Do

not install in areas subject to combustible vapors or gases. Before wiring to power supply and during servicing or relamping, turn

off power at fuse or circuit breaker. All servicing or relamping must be performed by qualiﬁed service personnel.

Product must be grounded to avoid potential electric shock or other potential hazard. Product must be

mounted in locations and at heights and in a manner consistent with its intended use, and in compliance

with the National Electrical Code and local building codes. The use of accessory equipment not recommended by the

manufacturer or installed contrary to instructions may cause an unsafe condition. Do not block light emanating from product in

whole or part, as this may cause an unsafe condition. Do not allow items such as drapes, curtains, screens or the like to come into

contact with the product or to block light from the product, as this may cause an unsafe condition.

CAUTION: TO REDUCE THE RISK OF ELEC-

TRICAL SHOCK, MAKE CERTAIN THAT THE

POWER SUPPLY IS OFF BEFORE INSTALLING

OR SERVICING THIS FIXTURE.

1. Bend hanger bar brackets as shown (shipped

ﬂat). Install the ﬁxture in the ceiling using B24 or

B6 hanger bars (ordered separately), or mount-

ing channel, bar, or conduit (by others) placed

in the adjustable brackets. Mount the ﬁxture in

the ceiling so that the weight of the ﬁxture is

securely supported by the hanger bars, mounting

channels, bars, conduit, and/or hanger wires

secured to the building stucture.

2. Adjust the ﬁxture so the bottom of the plaster

ﬂange is ﬂush with the ﬁnished ceiling line and

in alignment with adjacent ﬁxtures. Secure

mounting brackets by tightening wing nuts on

either side of the ﬁxture.

3. Determine where the supply wiring conduit will

enter the J-Box, remove the appropriate knock-

out, assemble the appropriate connector for the

supply wire used, and attach it in conformance

with the National Electrical Code.

4. Remove J-Box cover plate(s). Connect ground

wires to green ground leads. Connect white

(common) to white (leads). Connect power

supply (line) to black lead(s). Reinstall J-Box

cover. WARNING: DO NOT pinch wires

between J-Box/ballast cover and J-Box.

Consult a qualiﬁed electrician for all

other options that require other wiring

conﬁgurations.

5. Install reﬂector (ordered separately) after all ceil-

ing installation and ﬁnishing work is complete.

Follow installation instructions provided with

reﬂector.

6. Install the proper lamp (by others).

Hanger brackets are

supplied flat. Bend the

brackets along the three

oblong holes punched in

the bracket 1/3rd of the

way from each end.

Wing Nut (2)

Socket Cup

Plaster Frame

J-Box Cover (2)

B24 Hanger Bar

(Order Separately)

Reflector

(Order Separately)

INSTALLATION INSTRUCTIONS

LITEFRAME ELECTRONIC BALLAST

METAL HALIDE

LF6MH EB & LF8MH EB

BALLAST REPLACEMENT

MAKE CERTAIN THAT THE POWER SUPPLY IS OFF

Note wire connections and remove wire connectors. Loosen the two hex nuts holding

the ballast to the J-Box. Slide the ballast towards opening in keyhole slots and lift bal-

last off J-Box. Replace ballast by following these steps in reverse order.

CAUTION: DO NOT ATTEMPT TO MODIFY OR REWIRE FACTORY IN-

STALLED WIRING ON THE FIXTURE. SAFETY AND PROPER OPERATION

OF THE FIXTURE DEPEND ON THE INTEGRITY OF THE WIRING.

THE PRODUCT MUST BE INSTALLED BY A PERSON FAMILIAR WITH THE

CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE HAZ-

ARDS INVOLVED, IN ACCORDANCE WITH THE APPLICABLE INSTALLA-

TION CODE.

KEEP THESE INSTALLATION INSTUCTIONS

InstructionSheet 1

Summary of Contents

Page 1 - InstructionSheet

InstructionSheetwww.prescolite.com Prescolite TollFree Technical Support 1.888.PRS.4TEC Hours: 8am - 5pm ET 701 Millennium Blvd, Gree

Related models: LF6MH EB

Comments to this Manuals

No comments

Prescolite LF8MH EB User Manual

Browse online or download User Manual for Lighting Prescolite LF8MH EB. Prescolite LF8MH EB User Manual

Summary of Contents

Related models: LF6MH EB

Comments to this Manuals

Related products and manuals for Lighting Prescolite LF8MH EB