In four easy steps, you can install D2LED in your next lighting design.
Before the ceiling is finished, run the appropriate line voltage (and 0-10V dimming control wiring if
applicable) to the approximate location where the D2LED will be installed.
QUICK AND EASY INSTALLATION
Use a 2 7/8" hole saw and
pilot drill to cut an opening for
the D2LED downlight. Because
of the small reflector flange of
the D2LED, the accuracy of this
hole is critical. Even a 3" hole
saw may leave a ceiling cut
out too large to be completely
hidden after installation.
Simply slide the J-tube closed until
it locks into place with the springs
on opposite ends of the assembly to
complete the third step.
WARNING: Do not pinch wires
between J-Tube cover and
endplates.
Pull the pre-existing wiring
below the ceiling and connect
to the J-tube assembly through
the 1/2" knockout. A 3/8" flex
conduit duplex connector may
be used to easily daisy chain
fixtures together. For end-of-run
applications, a standard 1/2"
connector can be used.
Because D2LED features 0-10
volt dimming capability, be sure
to include any low voltage wire
connections in this step. When
wiring for dimming, the low
voltage wiring installs through
the adjoining 1/2" knockout. A
second 3/8" flex conduit duplex
connector may be used in this
knock out where applicable.
STEP 2:
RUN WIRES TO J-TUBE
STEP 1:
MAKE CEILING CUTOUT
STEP 3:
SLIDE/SNAP J-TUBE CLOSED
www.prescolite.com • Prescolite TollFree Technical Support 1.888.PRS.4TEC • Hours: 8am - 5pm ET
701 Millennium Blvd • Greenville, SC 29607
With representatives offices in principal cities throughout North America.
Copyright 2011, 10/27/11 revision, All Rights Reserved - Printed in U.S.A.
Part No. . . . . . . . . . . . . . . . . . . . . . . . . . . . . 93036374
InstructionSheet
INSTALLATION INSTRUCTIONS
D2LED
IMPORTANT SAFETY INFORMATION. READ AND FOLLOW ALL SAFETY INSTRUCTIONS. Follow label information and instructions con-
cerning Wet or Damp Locations, installation near combustible materials, insulation, building materials, and proper lamping. Do not install
in areas subject to combustible vapors or gases. Before wiring to power supply and during servicing or relamping, turn off power at fuse or
circuit breaker. All installation servicing or relamping must be performed by qualified service personnel. Product must
be grounded to avoid potential electric shock or other potential hazard. Product must be mounted in locations and
at heights and in a manner consistent with its intended use, and in compliance with the National Electrical Code
and local codes. The use of accessory equipment not recommended by the manufacturer or installed contrary to instructions may cause
an unsafe condition. Do not block light emanating from product in whole or part, as this may cause an unsafe condition. Do not allow items
such as drapes, curtains, screens or the like to come into contact with the product or to block light from the product, as this may cause an
unsafe condition.
WARNING- This product contains chemicals known to the State of California to cause cancer, birth defects and/or other
reproductive harm. Thoroughly wash hands after installing, handling, cleaning, or otherwise touching this product.
(1 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals