Prescolite 6LCLEDWW User Manual download pdf

InstructionSheet

www.prescolite.com Prescolite TollFree Technical Support 1.888.PRS.4TEC Hours: 8am - 5pm ET

701 Millennium Blvd, Greenville, SC 29607

With representatives ofﬁces in principal cities throughout North America.

10/17/13

Part No ....................................................... 93044255

Sheet 1 of 1

IMPORTANT SAFETY INFORMATION. READ AND FOLLOW ALL SAFETY INSTRUCTIONS. Follow label information and instructions

concerning Wet or Damp Locations, installation near combustible materials, insulation, building materials, and proper lamping. Do

not install in areas subject to combustible vapors or gases. Before wiring to power supply and during servicing or relamping, turn

off power at fuse or circuit breaker. All servicing or relamping must be performed by qualiﬁed service personnel.

Product must be grounded to avoid potential electric shock or other potential hazard. Product must be

mounted in locations and at heights and in a manner consistent with its intended use, and in compliance

with the National Electrical Code and local building codes. The use of accessory equipment not recommended by the

manufacturer or installed contrary to instructions may cause an unsafe condition. Do not block light emanating from product in

whole or part, as this may cause an unsafe condition. Do not allow items such as drapes, curtains, screens or the like to come into

contact with the product or to block light from the product, as this may cause an unsafe condition.

WARNING - This product contains chemicals known to the State of California to cause cancer, birth defects and/or other

reproductive harm. Thoroughly wash hands after installing, handling, cleaning, or otherwise touching this product.

CAUTION: TO REDUCE THE RISK OF ELECTRICAL SHOCK, MAKE CERTAIN THAT

THE POWER SUPPLY IS OFF BEFORE INSTALLING OR SERVICING THIS FIXTURE!

1. Install the fixture in the ceiling using the hanger bars (supplied), or mounting channel or bars (by others) placed in the adjustable mounting

brackets. Mount the fixture in the ceiling so that the weight of the fixture is supported by the hanger bars, mounting channel, bar, and/or

hanger wires secured to the building structure.

2. Adjust the fixture so the bottom of the plaster flange opening is flush with the finished ceiling line and in alignment with adjacent fixtures.

Secure mounting brackets by tightening wing nuts on either side of the fixture.

3. Determine where the supply wiring conduit will enter the J-Box and attach it in conformance with the National Electric Code.

4. Remove J-Box cover plate. Remove appropriate knockout and assemble appropriate connector for the supply wire used. Connect ground

wires to green ground leads. Connect white (common) to white (leads). Connect power supply (line) to black lead(s). Reinstall J-Box cover.

WARNING: DO NOT pinch wires between J-Box/ballast cover and J-Box. Consult a qualified electrician for all other

options that require other wiring configurations.

5. Pull electrical cover (1) down through opening in ﬁxture.

6. Insert connector (2) into connector (3) and snap ﬁrmly together.

7. Carefully put wires and connectors (2) & (3) into cover (1). Place tab (5) into slot of reﬂector (6) and screw (4) into hole in reﬂector (6). Make

sure there are not any wires pinched between item (1) and item (6). Tighten screw (4).

8. Squeeze two torsion springs (7) together and insert ends into two brackets (8). Push trim assembly up towards ceiling until springs draw trim

ﬁrmly against the ceiling.

KEEP THESE INSTALLATION INSTRUCTIONS

INSTALLATION INSTRUCTIONS

LITEFRAME

LC6LED, 6LCLED, and 6LCLEDWW

SCREW ITEM 4

INTO THIS HOLE

Item 8 can be put

in other locations to

change orientation of

wall wash.

4 3

2 1

REV DATE RECORD DESN CHCK

CRITICAL DIMENSIONS

UNSPECIFED TOLERANCES: INCHES

X.X=



0.1 X.XX=



0.03 X.XXX=



0.010

FRACTIONS=



1/32 ANGULAR TOLERANCE=





CATALOG NO.

ENGINEERING:

CHECKED BY:

THIRD ANGLE PROJECTION

DRAWN BY:

DO NOT SCALE PRINT

CONFORMS TO ASME Y14.5M

DIMENSIONS IN [ ] IN MM

DIMENSIONS IN INCHES

This document contains confidential and proprietar y information of

Prescolite. Receipt or possession of this document does not convey any

rights to re produce or disclose its contents, or to make, use , or sell

anything it may disclose. Reproduction, disclosure, or use of the document

or its conte nts, without the specific written authorization of Pres colite, ma y

violate the intellectual property rights of Prescolit e.

MATERIAL: FINISH: PART NO.

SCALE SIZE DRAWING NO. REV.

1:2

csteadman

MDR

08/09/13

01/04/13

ASSY-LT ENG 6LCLED / P8104/5/6

93043805

SHT 3

4 SHTS

---

--- --- ---

CLMMDREC-13032501104/29/13D

MDRCWWEC-13071000208/01/13E

-CASEC-09/20/13F

* SEE NOTES ON SHEET 4 *

150

ASSEMBLY FOR

6LCLED5WW / P8104 SERIES

6LCLED6WW / P8105 SERIES

130

100

LOCATE ITEM 60 AS SHOWN

SO WIRE LEADS ARE CLOSE

TO HOLE (NOT SHOWN) IN ITEM 70

LOCATE ITEM 30 AND ITEM 40

AS SHOWN SO WIRES ON

ITEM 60 ARE INSIDE OF NOTCHES

120 SEE DETAIL A

SEE DETAIL A

120

INSTALL ITEM 20 WITH

SMOOTH SIDE DOWN

160

DETAIL A

PRESS ITEM 10 UP

AND HOLD AGAINST

ITEM 70 WHILE

SLIDING ITEM 120

(3X) DOWN AGAINST

ITEM 70 ON ALL

THREE TABS OF

ITEM 10.

SEE NOTE 3

ON SHEET 4

110

6LCLED7WW / P8106 SERIES

6LCLED5WW / P8104 SERIES

6LCLED6WW / P8105 SERIES

ASSEMBLY FOR

6LCLED7WW / P8106 SERIES

ITEM 75 MOUNTS TO

ITEM 130 BY ITEM 80

AND IS INSIDE OF ITEM 70

FLANGE

OF ITEM 70

4 3

2 1

REV DATE RECORD DESN CHCK

CRITICAL DIMENSIONS

UNSPECIFED TOLERANCES: INCHES

X.X=



0.1 X.XX=



0.03 X.XXX=



0.010

FRACTIONS=



1/32 ANGULAR TOLERANCE=





CATALOG NO.

ENGINEERING:

CHECKED BY:

THIRD ANGLE PROJECTION

DRAWN BY:

DO NOT SCALE PRINT

CONFORMS TO ASME Y14.5M

DIMENSIONS IN [ ] IN MM

DIMENSIONS IN INCHES

This document contains confidential and proprietar y information of

Prescolite. Receipt or possession of this document does not convey any

rights to re produce or disclose its contents, or to make, use , or sell

anything it may disclose. Reproduction, disclosure, or use of the document

or its conte nts, without the specific written authorization of Pres colite, ma y

violate the intellectual property rights of Prescolit e.

MATERIAL: FINISH: PART NO.

SCALE SIZE DRAWING NO. REV.

1:2

csteadman

MDR

08/09/13

01/04/13

ASSY-LT ENG 6LCLED / P8104/5/6

93043805

SHT 3

4 SHTS

---

--- --- ---

CLMMDREC-13032501104/29/13D

MDRCWWEC-13071000208/01/13E

-CASEC-09/20/13F

* SEE NOTES ON SHEET 4 *

150

ASSEMBLY FOR

6LCLED5WW / P8104 SERIES

6LCLED6WW / P8105 SERIES

130

100

LOCATE ITEM 60 AS SHOWN

SO WIRE LEADS ARE CLOSE

TO HOLE (NOT SHOWN) IN ITEM 70

LOCATE ITEM 30 AND ITEM 40

AS SHOWN SO WIRES ON

ITEM 60 ARE INSIDE OF NOTCHES

120 SEE DETAIL A

SEE DETAIL A

120

INSTALL ITEM 20 WITH

SMOOTH SIDE DOWN

160

DETAIL A

PRESS ITEM 10 UP

AND HOLD AGAINST

ITEM 70 WHILE

SLIDING ITEM 120

(3X) DOWN AGAINST

ITEM 70 ON ALL

THREE TABS OF

ITEM 10.

SEE NOTE 3

ON SHEET 4

110

6LCLED7WW / P8106 SERIES

6LCLED5WW / P8104 SERIES

6LCLED6WW / P8105 SERIES

ASSEMBLY FOR

6LCLED7WW / P8106 SERIES

ITEM 75 MOUNTS TO

ITEM 130 BY ITEM 80

AND IS INSIDE OF ITEM 70

FLANGE

OF ITEM 70

6LCLED5WW

6LCLED6WW

6LCLED7WW

InstructionSheet 1

Summary of Contents

Page 1 - InstructionSheet

InstructionSheetwww.prescolite.com Prescolite TollFree Technical Support 1.888.PRS.4TEC Hours: 8am - 5pm ET 701 Millennium Blvd, Gree

Related models: 6LCLED | LC6LED |

Comments to this Manuals

No comments

Prescolite 6LCLEDWW User Manual

Browse online or download User Manual for Lighting Prescolite 6LCLEDWW. Prescolite 6LCLEDWW User Manual

Summary of Contents

Related models: 6LCLED | LC6LED |

Comments to this Manuals

Related products and manuals for Lighting Prescolite 6LCLEDWW