Prescolite RHD8_EB QUARTZ RESTRIKE (QR) & DCB User Manual download pdf

InstructionSheet

www.prescolite.com • Prescolite TollFree Technical Support 1.888.PRS.4TEC • Hours: 8am - 5pm ET

701 Millennium Blvd., Greenville, SC 29607

With representatives of

fices in principal cities throughout North

America.

Part No. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .93012110

InstructionSheet

INSTALLATION INSTRUCTIONS

RHD6_EB & RHD8_EB

QUARTZ RESTRIKE (QR) & DCB

Housing with Quartz Restrike Option - (Factory Wired):

Install the housing per the installation instructions provided with the housing.

Open Reflectors:

1. After the housing is installed, extend the QR/DCB conduit assembly down through the housing aperture as shown.

Place the end of the cast socketholder through the 7/8" diameter hole in the side of the reflector

. Secure it in position by pushing

the retaining clip onto the dentents on the end of the socketholder from the inside of the reflector. (See illustration on other side.)

3. Place the reflector in the housing aperture. Make sure the two mounting screws extend through the keyholes in the top of the

reflector.

Tighten the screws to draw the trim ring up flush against the ceiling.

4. Install correct double contact bayonet base quartz lamp per table on other side.

allast

QR/DCB

Conduit Assembly

MPORTANT SAFETY INFORMATION. READ AND FOLLOW ALL SAFETY INSTRUCTIONS. Follow label information

nd instructions concerning Wet or Damp Locations, installation near combustible materials, insulation, building materials,

nd proper lamping. Do not install in areas subject to combustible vapors or gases. Before wiring to power supply and

uring servicing or relamping, turn off power at fuse or circuit breaker.

ll servicing or relamping must be performed by

ualified service personnel. Product must be grounded to avoid potential electric shock or other potential hazard.

roduct must be mounted in locations and at heights and in a manner consistent with its intended use, and in

ompliance with the National Electrical Code and local codes.

he use of accessory equipment not recommended by

he manufacturer or installed contrary to instructions may cause an unsafe condition. Do not block light emanating from

roduct in whole or part, as this may cause an unsafe condition. Do not allow items such as drapes, curtains, screens or

he like to come into contact with the product or to block light from the product, as this may cause an unsafe condition.

Reflector

DCB or 120V QR Shown

277V QR version will include a Step-Down

ransformer

1 2

InstructionSheet 1

Summary of Contents

Page 1 - InstructionSheet

InstructionSheetwww.prescolite.com • Prescolite TollFree Technical Support 1.888.PRS.4TEC • Hours: 8am - 5pm ET701 Millennium Blvd., Greenville, SC 2

Page 2

THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION CODE BY A PERSONFAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PROD

Comments to this Manuals

No comments

Prescolite RHD8_EB QUARTZ RESTRIKE (QR) & DCB User Manual

Browse online or download User Manual for Lighting Prescolite RHD8_EB QUARTZ RESTRIKE (QR) & DCB. Prescolite RHD8_EB QUARTZ RESTRIKE (QR) & DCB User Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for Lighting Prescolite RHD8_EB QUARTZ RESTRIKE (QR) & DCB