Prescolite LBC6S Surface Mount User Manual

Browse online or download User Manual for Lighting Prescolite LBC6S Surface Mount. Prescolite LBC6S Surface Mount User Manual

  • Download
  • Add to my manuals
  • Print
  • Page
    / 1
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 0
www.prescolite.com Prescolite TollFree Technical Support 1.888.PRS.4TEC Hours: 8am - 5pm ET
InstructionSheet
Part No. . . . . . . . . . . . . . . . . . . . . . . . . . . . . 93041498
InstructionSheet
LBC6S Surface Mount Installation Instructions
CAUTION: DO NOT ATTEMPT TO MODIFY OR REWIRE FACTORY-INSTALLED WIRING ON THE FIXTURE. SAFETY AND PROPER
OPERATION OF THE FIXTURE DEPEND ON THE INTEGRITY OF THE WIRING.
KEEP THESE INSTALLATION INSTRUCTIONS
Surface Mount Instructions
1. Connect black, white, and ground fixture wires to the respec-
tive black, white, and ground supply wires with wire nuts.
2. Secure fixture to ceiling/J-Box with screws provided by others.
3. Align appropriate keyhole slots in fixture with J-Box screws
and rotate to lock in place.
4. Tighten screws to secure fixture.
IMPORTANT SAFETY INFORMATION. READ AND FOLLOW ALL SAFETY INSTRUCTIONS. Follow label information and instructions con-
cerning Wet or Damp Locations, installation near combustible materials, insulation, building materials, and proper lamping. Do not install
in areas subject to combustible vapors or gases. Before wiring to power supply and during servicing or relamping, turn off power at fuse or
circuit breaker. All installation servicing or relamping must be performed by qualified service personnel. Product must
be grounded to avoid potential electric shock or other potential hazard. Product must be mounted in locations and
at heights and in a manner consistent with its intended use, and in compliance with the National Electrical Code
and local codes. The use of accessory equipment not recommended by the manufacturer or installed contrary to instructions may cause
an unsafe condition. Do not block light emanating from product in whole or part, as this may cause an unsafe condition. Do not allow items
such as drapes, curtains, screens or the like to come into contact with the product or to block light from the product, as this may cause an
unsafe condition.
701 Millennium Boulevard Greenville, SC 29607
With representatives offices in principal cities throughout North America.
Copyright 2012, 4/12/12 revision, All Rights Reserved - Printed in U.S.A.
WARNING- This product contains chemicals known to the State of California to cause cancer, birth defects and/or
other reproductive harm. Thoroughly wash hands after installing, handling, cleaning, or otherwise touching this
product.
CAUTION: TO REDUCE THE RISK OF ELECTRICAL SHOCK, MAKE CERTAIN THAT THE
POWER IS OFF BEFORE INSTALLING OR SERVICING THIS FIXTURE
XX XX/XX/XX EC-XXXX --- ---
D
C
B
A
12
8 7 6 5 4 3
2
D
C
B
A
12
8 7 6 5 4 3
This document contains confidential and proprietary information of
Prescolite. Receipt or possession of this document does not convey any
rights to reproduce or disclose i ts con tents , o r to make, use , or s ell
anything it may disclose. Reproduction, disclosure, or use of the document
or its conten ts, w ithou t the specific written autho rization of Prescolite, may
violate the intellectual property rights of Prescoli te .
UNSPECIFED TOLERANCES: INCHES
X.X=
0.1 X.XX=0.03 X.XXX=0.010
FRACTIONS=
1/32 ANGULAR TOLERANCE=1
CRITICAL DIMENSIONS
PART NO:
REV.
FINISH:MATERIAL:
THIRD ANGLE PROJECTION
DRAWN BY:
DO NOT SCALE PRINT
CONFORMS TO ASME Y14.5M
DIMENSIONS IN [ ] IN MM
DIMENS IONS IN INCHES
CHECKED BY:
ENGINEERING:
CATALOG NO:
SCALE
D
SIZE DRAWING NO.
CHCKDESNRECORDDATEREV
SHT 1
1 SHTS
AS SPECIFIED
93041498
93040977
A
ASSY-LBC6x
swbodell 04/03/12
--- --/--/--
---
--- --/--/--
PV:1
NOTES: UNLESS OTHERWISE SPECIFIED
1. DEBURR AND BREAK SHARP CORNERS.
Page view 0
1

Summary of Contents

Page 1 - InstructionSheet

www.prescolite.com • Prescolite TollFree Technical Support 1.888.PRS.4TEC • Hours: 8am - 5pm ETInstructionSheetPart No. . . . . . . . . . .

Comments to this Manuals

No comments